• ASTM A1018/A1018M-04
Provide PDF Format

Learn More

ASTM A1018/A1018M-04

  • Standard Specification for Steel, Sheet and Strip, Heavy-Thickness Coils, Hot-Rolled, Carbon, Commercial, Drawing, Structural, High-Strength Low-Alloy, and High-Strength Low-Alloy with Improved Formability
  • standard by ASTM International, 04/01/2004
  • Publisher: ASTM

$26.00$52.80


1.1 This specification covers hot-rolled, heavy-thickness coils beyond the size limits of Specification A 1011/A 1011M.

1.2 The product is available in five designations: Commercial Steel, Drawing Steel, Structural Steel, High-Strength Low-Alloy Steel, and High-Strength Low-Alloy Steel with Improved Formability.

1.3 This material is available only in coils described as follows:

ProductSize Limits, Coils Only
Width, in. [mm]Thickness, in. [mm]
StripOver 8 to 12, incl[Over 200 to 300]0.230 to 1.000, incl[Over 6.0 to 25]
SheetOver 12 to 48, incl[Over 300 to 1200]0.230 to 1.000, incl[Over 6.0 to 25]
SheetOver 48[Over 1200]0.180 to 1.000, incl[Over 4.5 to 25]

1.4 Sheet and strip in coils of sizes noted in are covered by this specification only with the following provisions:

1.4.1 The material is to be fed directly from coils into a blanking press, drawing or forming operation, tube mill, rolling mill, or sheared or slit into blanks for subsequent drawing or forming.

1.4.2 The material is not to be converted into steel plates for structural or pressure vessel use unless tested in complete accordance with the appropriate sections of Specifications A 6/A 6M (plates provided from coils) or A 20/A 20M (plates produced from coils). Plate produced in this manner is no longer governed by this sheet steel specification and since this material is now plate, the appropriate plate standard shall apply.

1.4.3 The dimensional tolerances of Specification A 635/A 635M are applicable to material produced to this specification.

1.4.4 Not all strength levels are available in all thicknesses. The user should consult the producer for appropriate size limitations.

1.5 The values stated in either inch-pound units or SI units [metric] are to be regarded separately as standard. Within the text the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other.

Related Products

ASTM D4513-97

ASTM D4513-97

Standard Test Method for Particle Size Distribution of Catalytic Materials by Sieving..

$23.00 $46.80

ASTM D411-08

ASTM D411-08

Standard Test Methods for Shellac Used for Electrical Insulation (Withdrawn 2013)..

$26.00 $52.80

ASTM D4038-95a

ASTM D4038-95a

Standard Performance Specification for Women's and Girls' Woven Dress and Blouse Fabrics (Withdrawn ..

$23.00 $46.80

ASTM C627-93(2007)

ASTM C627-93(2007)

Standard Test Method for Evaluating Ceramic Floor Tile Installation Systems Using the Robinson-Type ..

$26.00 $52.80