ASTM D1264-12
- Standard Test Method for Determining the Water Washout Characteristics of Lubricating Greases
- standard by ASTM International, 12/01/2012
- Publisher: ASTM
$23.00$46.80
1.1 This test method covers the evaluation of the resistance of a lubricating grease to washout by water from a bearing, when tested at 38 and 79°C (100 and 175°F) under the prescribed laboratory conditions. It is not to be considered the equivalent of service evaluation tests. Precision and bias was determined using grease ranging from NLGI 3 to 0 grades in the research report (see Section 10).
Related Products
ASTM E1865-97
Standard Guide for Open-Path Fourier Transform Infrared (OP/FT-IR) Monitoring of Gases and Vapors in..
$30.00 $60.00
ASTM D4312-95a(2005)
Standard Test Method for Toluene-Insoluble (TI) Content of Tar and Pitch (Short Method)..
$23.00 $46.80
ASTM F994-86(2006)
Standard Specification for Design and Installation of Overboard Discharge Hull Penetration Connectio..
$26.00 $52.80
ASTM E1504-92(2001)
Standard Practice for Reporting Mass Spectral Data in Secondary Ion Mass Spectrometry (SIMS)..
$23.00 $46.80