ASTM E2092-13
- Standard Test Method for Distortion Temperature in Three-Point Bending by Thermomechanical Analysis
- standard by ASTM International, 09/01/2013
- Publisher: ASTM
$22.00$44.00
1.1 This test method describes the determination of the temperature at which the specific modulus of a test specimen is realized by deflection in three-point bending. This temperature is identified as the distortion temperature. The distortion temperature is that temperature at which a test specimen of defined geometry deforms to a level of strain under applied stress of 0.455 MPa (66 psi) (Method A) and 1.82 MPa (264 psi) (Method B) equivalent to those used in Test Method D648. The test may be performed over the range of temperature from ambient to 300°C.
Note 1-This test method is intended to provide results similar to those of Test Method D648 but are performed on a thermomechanical analyzer using a smaller test specimen. Equivalence of results to those obtained by Test Method D648 has been demonstrated on a limited number of materials. The results of this test method shall be considered to be independent and unrelated to those of Test Method D648 unless the user demonstrates equivalence.Related Products
ASTM B359/B359M-02(2006)
Standard Specification for Copper and Copper-Alloy Seamless Condenser and Heat Exchanger Tubes With ..
$30.00 $60.00
ASTM C942-99
Standard Test Method for Compressive Strength of Grouts for Preplaced-Aggregate Concrete in the Labo..
$23.00 $46.80
ASTM D7816-12
Standard Test Method for Enumeration of Halophilic and Proteolytic Bacteria in Raceway Brine, Brine..
$22.00 $44.00