Provide PDF Format
BHMA A156.19-2007
- Power Assist and Low Energy Power Operated Doors
- standard by Builders Hardware Manufacturers Association, 04/20/2007
- Publisher: BHMA
$20.00$40.00
1.1 Scope: Requirements in this Standard apply to power assist doors, low energy poweroperated doors or low energy power open doors for pedestrian use, and some small vehicular useand not provided for in ANSI/BHMA A156.10 for Power Operated Pedestrian Doors. Includedare provisions intended to reduce the chance of user injury or entrapment.
1.1.1 This Standard does not attempt to assess any factors that exist with respect to customdesign installations which are not required to meet the requirements of this Standard.
1.2 Required dimensions are expressed in US units first and the SI (metric) equivalents givenin parentheses are approximate. All values which do not carry specific tolerances or are notmarked maximum or minimum shall have the following tolerances: Linear dimensions shall be ?1/16 in (1.6 mm). Pounds or pound force shall be ? 5%. Angular measurements shall be ? 4degrees. Voltage measurements shall be ? 5 %. Temperature measurements shall be ? 4 degreesF (?2 degrees C).
1.3 Definitions of terms used but not found in this Standard are in ANSI/BHMA A156.10 forPower Operated Pedestrian Doors, available at www.buildershardwre.com and the AmericanNational Standards Institute, Inc., 11 West 42nd Street, New York, NY 10036.
1.4 All references to time delay, opening speed and forces, in this standard, refer to the operatorin the power mode as opposed to the manual mode.
This item is available as part of a discounted standards set covering Door Controls .
1.1.1 This Standard does not attempt to assess any factors that exist with respect to customdesign installations which are not required to meet the requirements of this Standard.
1.2 Required dimensions are expressed in US units first and the SI (metric) equivalents givenin parentheses are approximate. All values which do not carry specific tolerances or are notmarked maximum or minimum shall have the following tolerances: Linear dimensions shall be ?1/16 in (1.6 mm). Pounds or pound force shall be ? 5%. Angular measurements shall be ? 4degrees. Voltage measurements shall be ? 5 %. Temperature measurements shall be ? 4 degreesF (?2 degrees C).
1.3 Definitions of terms used but not found in this Standard are in ANSI/BHMA A156.10 forPower Operated Pedestrian Doors, available at www.buildershardwre.com and the AmericanNational Standards Institute, Inc., 11 West 42nd Street, New York, NY 10036.
1.4 All references to time delay, opening speed and forces, in this standard, refer to the operatorin the power mode as opposed to the manual mode.
This item is available as part of a discounted standards set covering Door Controls .
Related Products
